Hydraulic Press Brakes with DRO unit

Hydraulic Press Brakes with DRO unit

Hydraulic Press Brakes with DRO unit

The workstations that demand more technologically advanced equipment can rely on the well-engineered Hydraulic Press Brakes with DRO manufactured and supplied by Monotech Engineers. These high-tonnage press brakes have a digital read out, and a digital positioning feed table so as to activate the next punch automatically.

Standard Feature Accessories:
• Main drive standard make motor
• Electrical control panel with three speed inch,single cycle,Auto mode of operation.
• Two front sheet supports
• Manual back gauge with micro-adjustment swing stoppers. pair of lifting chains.
• fine stroke adjustment rod with limit switches.
• One suitable 5 way die and blade. 
• (segmented for full length,EN-9 not covered under warranty)
• Moveble console with emergency stop.
• Tonnage indicating - adjustment device.
• Manual centralized lubrication system with hand pump.
• bending chart.

Feature: 
• Mono Block Welded Steel Frame ultra tested-2062
• steel plates rigid to provide Accurate bending.
• All pivots have hardened of ground pin bushes of five
• piece guide slide lubricated by central hand pump
• Repetitive accuracy is within +0.03mm Ram travel parallelism with out using sensitive & complex servo Hydraulics.
• Most reliable Hydraulic components & sealing for international reputed design for 350 bar against operating pressire of 160 bar maximum.
• Three cycles operation inch,Single cycle&Auto for grater operator convenience.
• Three speed operation reduces ideal travel time which improves productivity.
• Bending force easily adjustable From front for forging tool of bending material.

Enquire Now